Bought an EV but Your Panel Is Full?
Getting a new electric car is exciting until you look at your panel. Common problems we hear:
- Charging from a wall outlet adds only a few miles per hour
- The panel has no open slots for a 240 volt breaker
- The garage is far from the panel
- You are not sure if your service can handle a charger
- The rebate paperwork looks confusing
Many older homes here still run 100 amp panels, which can make adding a charger tricky but rarely impossible. We look at your loads, your panel and your parking spot, then find the simplest way to get you charging.
Charger Setups We Install at Home
Tesla Wall Connector Installation
We install Tesla Wall Connectors on garage walls or driveway pedestals, set to SMUD rebate rules from the start. Two Tesla homes can share power between two connectors without overloading the panel.
NEMA 14 50 Outlet Installation
A 240 volt outlet works with most plug in Level 2 chargers and RVs. We install it with GFCI protection, as code calls for in garages, and size the circuit to your panel.
Hardwired Universal Chargers
For non Tesla drivers, we hardwire Level 2 chargers from brands like ChargePoint, Emporia and others. Hardwiring skips the outlet and is often the most reliable setup.

Load Management Devices
An EV charger with load management pauses charging when your AC or dryer runs, so you can skip a panel upgrade. SMUD rebates qualifying devices up to $200.
Choosing between them comes down to your car, your parking spot and how much you drive. We help you pick the setup that fits, then wire it to qualify for rebates.
Chargers We Installed Near North Highlands
Recent installs include a garage EV charger installation for a Hillsdale family with a 100 amp panel, a Wall Connector on a driveway pedestal near Elkhorn Boulevard and an EV charger installation Antelope CA owner booked for a new Model Y.



On the Hillsdale job, a load calculation showed the 100 amp panel could carry a 32 amp charger with a load device, so the family skipped a panel upgrade. The driveway pedestal near Elkhorn Boulevard used underground conduit to reach a car parked outside.
Five Steps to a Working Home Charger
Every charger install follows the same five steps, so you know what happens from first call to first charge.
- Call or Text Us: Send a photo of your panel, its label and the spot where you park. We can usually tell right away whether your panel has room.
- Get a Price Range: We look at your car, charger and loads and share a range on the phone. If a load device can avoid an upgrade, we mention it then.
- Approve a Written Price: On site, we run a load calculation and measure the wire run. You get one written price covering the charger circuit, permit and labor.
- We Do the Work: We file the permit, which California law says must be decided within 5 business days for complete EV applications, then install the circuit and test charging.
- Inspection and Sign Off: The county inspector checks the install, and you get the paperwork you need for SMUD rebate claims.
Most homeowners are charging within a week of their first call, depending on permit timing and charger delivery.
Charging Headaches We Solve for EV Owners
- Slow overnight charging: A wall outlet adds only a few miles per hour. A Level 2 charger fills most cars overnight.
- Breaker trips while charging: The circuit is undersized or shared. We run a dedicated line.
- No 240 volt outlet: We add one or hardwire a charger.
- Long garage runs: We plan the shortest clean route through the attic, crawlspace or conduit.
- Panel with no space: Tandem breakers, a subpanel or a load device can often solve it.
- Rebate paperwork: We wire and invoice to SMUD rules so your claim goes smoothly.
Most of these fixes take a single visit once the permit is approved.
If you rent, ask your landlord about a charger before you buy a car. Many owners approve a charger install when they see it adds value to the property, and we can provide a quote they can review.
Drivers We Set Up for Home Charging
| Driver | What We Usually Install |
|---|---|
| New EV owners | Level 2 charger with a dedicated circuit |
| Tesla owners | Wall Connector, with power sharing for two cars |
| Plug in hybrid owners | 240 volt outlet or a smaller charger |
| Two EV households | Load sharing setup |
| Renters with permission | Outlet installs approved by the owner |
Not sure which charger to buy? Tell us your car and daily miles. For most commuters, a 32 amp charger fills the battery overnight with room to spare, and it fits SMUD rebate rules.
Thinking about a second EV in the next few years? Tell us now. We can size the circuit and choose a charger that supports load sharing later, so adding the second car does not mean starting over.
Chargers Wired to SMUD Rebate Rules
SMUD (Sacramento Municipal Utility District) Charge@Home has specific rules, and missing one can cost you the rebate. We follow them from the start:
- Set the charger to 32 amps max on a 40 amp breaker
- Show that setting clearly on the invoice
- Give you photos and permit records for your claim
As a SMUD EV charger rebate installer, we check current program rules before every job, since they can change.
Keep your invoice, permit record and the photo of the charger setting together. Those three items are what most rebate claims ask for.
We Try to Avoid a Panel Upgrade First
A panel upgrade can turn a charger install into a much bigger project. Before suggesting one, we run a load calculation that adds up everything your home uses.
If the math works, we install on your current service. If it is close, a load management device may let you skip the upgrade, and SMUD rebates those devices up to $200. We only recommend a panel upgrade when your home truly needs one, and we show you why.
Here is a quick way to think about it:
| Your Home | Likely Path |
|---|---|
| Gas heat, gas range, one EV | Charger on current service |
| Two AC units plus one EV | Load device or tandem breakers |
| EV plus heat pump plus induction | 200 amp upgrade |
County EV Permit Filed for You
Level 2 chargers need an electrical permit. As an EV charger permit Sacramento County office regular, we handle it:
- Online filing: We submit the permit before install day.
- Fast decisions: California’s AB 1236 requires a decision on complete EV charger permit applications within 5 business days.
- Inspection booked: We schedule the inspection and meet the inspector.
The permit fee is included in your written price.
Once the permit is approved, most installs take a few hours. You can usually charge the same evening, with the inspection booked shortly after.
Home Charger Install Pricing in North Highlands
Your home EV charger install cost depends mostly on distance from the panel and whether the panel needs work.
| Install Type | What Drives the Price |
|---|---|
| Outlet only, near the panel | Short run, simplest install |
| Hardwired charger, near the panel | Short run plus charger mounting |
| Long run to the garage or driveway | Wire length, conduit and routing |
| Install with panel upgrade | Adds $2,500 to $8,000 for panel and meter work |
Panel ranges from SacValley Contractors 2026.
Rebates can offset part of the cost. Here is how the main options compare:
| 14 50 Outlet | Hardwired Charger | Charger With Load Device |
|---|---|---|
| Lower cost | Mid range cost | Mid range plus device |
| Works with plug in chargers | Most reliable connection | Avoids a panel upgrade |
| GFCI breaker needed | Best for daily use | SMUD rebate up to $200 |
Your EV charger install price North Highlands quote comes in writing before we start.
Charger hardware is separate from installation. If you have not bought one yet, we can suggest models that work well with SMUD rebates and fit your panel, so you do not pay for features you will not use.
EV Owners Rate Their Install
Reviews from local drivers help you choose the best EV charger installer North Highlands has.
Text a Photo of Your Panel and Garage
Two photos, one of your panel and one of where you park, are all we need for a price range.
FAQs: EV Charger Installation Questions
Questions drivers ask before calling about EV charger installation near me.
Simple installs near the panel cost far less than long runs or jobs needing a panel upgrade. We price from a photo of your panel and parking spot, then confirm in writing.
Not always. We run a load calculation first. Many homes can add a 32 amp charger with a load management device, which SMUD rebates up to $200.
Yes. Charge@Home needs the charger set to 32 amps max on a 40 amp breaker, shown on the invoice. We wire and write it that way.
Yes. Sacramento County requires an electrical permit for Level 2 chargers. We file it online and book the inspection, and the fee is in your price.
Often within the week. California law requires a decision on complete EV permit applications within 5 business days, and we file right after you approve.
Areas We Serve





